Door latch with padlock3/10/2023 That meant that the entire mechanism, including the manual thumb turn, stuck four inches out from the door.Ī small Phillips head screwdriver is included, but a solution that did not involve removing and replacing tiny screws would have been preferable. If you are using this with a standard deadbolt that has a thumb turn nearly flush with the door, you might not need to adjust it at all, but the chunky jimmy-proof lock that I tested it on required the adapter to be almost fully extended to fit over the lock. The height depends on the thickness of the lock. This is rather fiddly, involving removing four screws, moving the adapter to the right height and then replacing the screws to secure the bracket. Once you know how the smart lock will fit, you adjust the height of the base adapter, the part that attaches the Switchbot lock to the door. The device can be installed horizontally or vertically: an unusual and useful feature for oddly-shaped doors. I used the extra large adapter to fit over the big thumb turn of my lock.Īfter that, you attach the adapter to the lock and put it over the lock to confirm that it will fit, and to pick which way around it will go. Three are supplied with the Smartbot lock that should work with various shapes and sizes of lock: medium, large and extra large. Next, you have to choose the thumb turn adapter that fits your lock. I tested it with a jimmy-proof style lock on my back door that has so far defied smartification. Instead, the Switchbot device fits over the top of the lock, turning the thumb turn with a motor and adapter.įirst, you have to figure out if the Switchbot lock will work with your lock: Switchbot has a guide to what types of locks will (and what won’t) work (opens in new tab). The installation process for the Switchbot Lock is a bit more complicated than most, because you don’t remove the existing lock. Switchbot Lock Smart Lock review: Installation The company says that the batteries should last up to six months if you use the lock 10 times each day. You might need a pile of these in the end: The lock, the keypad and the other Switchbot accessories that work with their system all use these batteries. The lock is powered by two CR-123A lithium batteries, which are a bit more expensive to replace than the more common AAA ones: two new CR-123A batteries will cost you about $6.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |